Gordak 952 He Error Portable Jun 2026

Trace each wire from the terminal block inside the handpiece to its corresponding terminal on the base station's main circuit board.

If the element is faulty, you can purchase a "Gordak 952 Heating Core" online quite cheaply. the old wires, noting their positions. Slide out the old ceramic core.

Expected Result: For a 220V unit, you should read roughly . For a 110V unit, it should read roughly 30 to 45 Ohms .

The is a popular, cost-effective, and portable 2-in-1 hot air soldering station commonly used for electronics repair, SMD soldering, and desoldering. Known for its reliability in hobbyist and professional repair shops alike, this unit combines a hot air gun and a soldering iron.

To avoid the "HE Error" in the future:

Never turn the station off directly using the main power switch while it’s hot. Always turn off the heat dial/button first and let the station run its auto-cooling process until the air turns cold. This prevents the ceramic core from heat-soaking and cracking.

If the element is faulty, you can buy a replacement ceramic heating element (often around $10) and solder it onto the internal PCB of the handle. Check the Handle Cable:

Measure resistance across the thinner thermocouple wires. 4. Check for Loose Internal Wires

"OL" or infinite resistance, indicating a "burnt out" wire. gordak 952 he error portable

Identify the two thicker wires (power for the heater) and two thinner wires (thermocouple/sensor).

Gordak 952 HE Error: Comprehensive Guide to Troubleshooting the Portable Rework Station

Parts & replacements

To avoid repeat failures:

If the element is confirmed dead, follow these steps for replacement: How to: Fix a Soldering Iron With The Error S-E or 5-E

Check for cold solder joints on the main transformer and the connector pins. Safety Warning High Voltage Hazard:

displays "H-E," it usually means the system cannot detect or maintain heat. This is often caused by:

When finished with a job, always let the gun cool down in its holder, allowing the fan to run until the air is cool before turning off the power. Trace each wire from the terminal block inside

) is designed for precision tasks like BGA and SMD component rework.