Xta-7000 Temperature Controller Manual

The is an intelligent digital temperature controller known for its high-precision PID control and user-friendly dual-display interface. Whether you are using it for industrial kilns, laboratory equipment, or DIY server room cooling, understanding its manual is key to maintaining stable temperatures. Core Specifications & Features

Do not change P , I , and D manually unless you understand PID control. Always run Auto-tune first.

Terminals 5, 6, and 7 (depending on model configuration). 3. Front Panel Interface

Connected in series with the load or contactor coil. xta-7000 temperature controller manual

Below is the complete parameter table for the XTA-7000 (factory reset typical values):

Changing the target temperature (setpoint) is a common operation.

: Used to enter parameter menus, switch fields, and confirm setting changes. The is an intelligent digital temperature controller known

The controller should be mounted on a flat, vibration-free panel in a location that adheres to the environmental specifications. Avoid direct sunlight, high humidity, high concentrations of dust, corrosive gases, or strong electromagnetic fields generated by large motors, contactors, or variable frequency drives (VFDs).

Before touching a single button, Elias recalled the first and most critical section of the : Safety and Installation.

The sensor is measuring below its structural limits or is wired backward. Temperature Over-range Always run Auto-tune first

| | Name | Function | |------------|---------------------------|-------------------------------------------------------------------------------| | PV | Process Value Display | Shows actual temperature (red, larger digits). | | SV | Set Value Display | Shows target temperature (green, smaller digits). | | SET | Parameter Access Key | Press 3 seconds to enter menu; short press to confirm. | | ◄ | Shift Key | Moves decimal point / selects digits in SV or parameter values. | | ▼ | Down Key | Decreases SV or parameter value. | | ▲ | Up Key | Increases SV or parameter value. | | OUT1 | Output 1 LED | Illuminates when heating output is active. | | AL1/2/3 | Alarm LEDs | Light when corresponding alarm condition is met. | | AT | Auto-tuning LED | Flashes during self-tuning. |

Hold the key for 3 seconds to enter the main parameter list. Common codes include: