Arduino Sensor Shield V5 0 Manual ((better))

The Arduino Sensor Shield V5.0 is a versatile expansion board designed to simplify the connection of multiple sensors, servos, and modules to an Arduino Uno or Mega. By breaking out each I/O pin into a 3-pin header (Signal, VCC, Ground), it eliminates the need for messy breadboards and soldering during prototyping.

#include <Servo.h> Servo myServo; myServo.attach(9); // the servo signal is on digital pin 9 myServo.write(90); // move servo to 90 degrees

| Feature | Details | |-----------------------|--------------------------------------------------| | Compatibility | Arduino Uno R3, Leonardo, Mega 2560 (partial) | | Digital I/O Ports | 14 (D0 – D13), each with 3-pin connector | | Analog Input Ports | 6 (A0 – A5), each with 3-pin connector | | I2C Interface | 1 (dedicated 4-pin: SDA, SCL, VCC, GND) | | UART Interface | 1 (D0/RX, D1/TX) via separate 4-pin header | | SPI Interface | Via ICSP header (MISO, MOSI, SCK, SS on D10) | | External Power (Servo) | 5V – 12V DC via 2-pin terminal block (optional) | | Board Dimensions | Approx. 68mm x 53mm |

Remove the SEL jumper and connect an external 5V power supply to the screw terminals. arduino sensor shield v5 0 manual

Six dedicated 3-pin headers for analog sensors. Communication Interfaces:

This area is usually labeled .

void loop() myServo.write(0); // Move to 0 degrees delay(1000); myServo.write(90); // Move to 90 degrees delay(1000); myServo.write(180); // Move to 180 degrees delay(1000); The Arduino Sensor Shield V5

Arduino Sensor Shield V5.0 Go to product viewer dialog for this item.

By removing the jumper and connecting a 5V–6V source to the blue screw terminal, you can power high-current devices like servos independently. This prevents electrical noise from resetting the Arduino.

Keep the jumper and pin mapping reference nearby—most "shield not working" issues are simply the wrong voltage or a conflict on D0/D1. 68mm x 53mm | Remove the SEL jumper

regulator. This configuration is suitable for low-power sensors (e.g., photoresistors, ultrasonic sensors, temperature chips).

The core philosophy of the Sensor Shield V5.0 is the grouping. Standard Arduino boards share a limited number of VCCcap V sub cap C cap C end-sub GNDcap G cap N cap D