Staples 17466 Laminator Manual
To avoid injury or fire:
| Problem | Likely Cause | Solution (from manual) | | :--- | :--- | :--- | | | Machine not fully warm | Wait 2 more minutes; red light must be steady. | | Pouch jams halfway | Pouch too thick (>5 mil) | Turn off unit. Pull pouch gently straight back. Use 3 mil pouch. | | Lamination has bubbles | Inserted sealed edge first | Next time, insert open edge first. Re-laminate with carrier. | | Ready light blinks | Overheating protection | Turn off for 15 minutes to cool. | | Rollers spin but no feed | Slippery pouch surface | Use provided carrier (cardstock folder). |
Confirm you are using the correct setting. If using 3-mil pouches on the 5-mil setting, the excess heat will melt and warp the plastic. Switch to the 3-mil setting and let the unit cool down. The Machine Will Not Turn On staples 17466 laminator manual
: Allow the laminated item to cool on a flat surface before trimming excess material. 3. Cold Lamination
The is a versatile 9.5-inch machine designed for home, school, and small office use. This guide provides comprehensive operating instructions, technical specifications, and troubleshooting tips to help you get the most out of your device. Quick Setup and Operating Instructions To avoid injury or fire: | Problem |
The machine becomes hot during operation; do not touch the casing near the exit slot.
Seconds felt like hours. Finally, the card emerged from the rear exit, transformed. What was once flimsy, stained paper was now a rigid, glossy artifact, impervious to future gravy spills. Use 3 mil pouch
Operating the Staples 17466 requires patience to allow the machine to reach the correct temperature. Step 1: Powering On and Selecting Mil Thickness
Before diving into the manual’s instructions, here is what the Staples 17466 is designed to do:
