Alps Electric Hidclass 10013 Updated [2021] Link

This method gives you more control, including the ability to manually install a driver you've downloaded from another source.

Microsoft distinguishes between two main categories of Windows updates:

The updated unit retains the original configuration dip-switches (located inside the case, accessible by sliding the bottom cover), but with new functions: alps electric hidclass 10013 updated

Restart your PC. Windows should automatically reinstall the base driver, or you can then trigger a fresh "Update driver" search.

In the evolving landscape of physical access control, the hardware that bridges the gap between a credential and a reader is just as critical as the lock on the door. Among the myriad of keyboards, card readers, and interface devices, one model has persistently captured the attention of security integrators and system administrators: the . This method gives you more control, including the

If your touchpad stops working after installing v1.0.0.13, right-click the device in Device Manager , go to Properties , and select Roll Back Driver to return to a stable version.

Microsoft released KB5031356 in April 2025 which tightened HID keyboard filters. Unplug the device, delete the "HID Keyboard" entry from Device Manager, reboot, and replug the 10013. In the evolving landscape of physical access control,

Driver updates for input devices are generally safe and recommended. They often fix security vulnerabilities in the HID stack and improve responsiveness. However, ALPS drivers have a history of behaving specifically.

| Symptom | Possible Cause | Solution | |---------|----------------|----------| | No read, LED not blinking | Power supply issue or poor grounding | Check 5V regulator; ensure GND is common with host | | Intermittent reads | Antenna mismatch or detuning | Re-tune antenna to 125 kHz; adjust coil inductance | | Wrong card number reported | Wiegand timing mismatch | Increase inter-bit timeout to 5ms; check for signal reflections | | Module reads but lags | Old firmware version | Verify you have REV B or later; flash updated firmware from Alps | | Reads only some HID cards | Frequency drift or unsupported format | Ensure cards are Prox (not iClass or Seos); test with 26-bit default |

: Many users report that Windows Update offers the 10.0.1.3 version repeatedly, even after it appears to have finished installing.

: In some deployment environments, this specific driver has been linked to system reboot loops.